Browse Ads

flathead 460 or Big 4 cylinder

flathead 460 or Big 4 cylinder

looking for 1 cylinder for a 1930 big 4 or Evinrude 460. Casting number on cylinder is SK 851 and…
11/26/2020
Total views: 23
WTB or trade VR/XR magplate

WTB or trade VR/XR magplate

I’m looking for a magplate free VR/XR, looks like a beast service motor magplate but the hole in the center…
11/25/2020
Total views: 16
scott at water 7 1/2 hp 1957

scott at water 7 1/2 hp 1957

i'm looking for the plaque that goes on the front top of hood where recoil comes out,, this is the…
11/24/2020
Total views: 15
Wanted to buy

Wanted to buy

Looking for a good powerhead for a 1954 Evinrude Fleetwin 7.5 HP
11/24/2020
Total views: 17
1935 CHAMPION PART

1935 CHAMPION PART

WTB 1935 Champion carb part as shown in photo. I DO NOT need the whole carb, just the fuel line…
11/24/2020
Total views: 34
WTB 1963 Evinrude 40HP shroud emblem needed.

WTB 1963 Evinrude 40HP shroud emblem needed.

I need the "Evinrude" emblem for the shroud on the "topic" motor. The part number is: 0205153. I have also…
09/29/2020
Total views: 74
Speeditwin - C Service parts

Speeditwin - C Service parts

Looking to buy for C-service project(s). 1) Short down tube/tower 2) Steel flywheel or after market racing flywheel Will also…
10/24/2020
Total views: 53
Wanted

Wanted

Looking for a Carb for a mighty mite 2 HP with electronic Ignition
07/31/2020
Total views: 27
Trade Johnson PR/SR-55 Mag plate for Johnson V50/70 mag plate.

Trade Johnson PR/SR-55 Mag plate for Johnson V50/70 mag plate.

looking for a magneto plate for my 1930 johnson V50. Recast are ok too, compete or not. i have a…
05/01/2020
Total views: 105
Looking for OMC 40hp electric start with wiring from mid 60s

Looking for OMC 40hp electric start with wiring from mid 60s

I'm looking for a decent OMC 40hp, 60s vintage, long shaft electric start for a friend. The engine should be…
11/20/2020
Total views: 27