Johnson 210 tower is twisted

Home › Forum › Ask A Member › Johnson 210 tower is twisted

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • July 15, 2020 at 10:40 am #208673
    jim-moffatt
    Participant

      US Member

      After my last run the Tower of my Johnson 210 is twisted about 10 degrees. Any suggested fixes?
      The tower consists of upper and lower castings attached to an aluminum tube.

      July 15, 2020 at 6:54 pm #208709
      Buccaneer
      Participant

        US Member

        Did the tube twist, or the castings twisted on the tube?

        Prepare to be boarded!

        July 16, 2020 at 8:12 am #208739
        jim-moffatt
        Participant

          US Member

          it appears that the crankcase lower cover twisted on the tube. Will take it apart today.

          July 16, 2020 at 5:52 pm #208818
          jim-moffatt
          Participant

            US Member

            The upper flange was held to the tube by two 3/16″ aluminum rivets which had sheared, I replaced them. Its now ready to test.

            • This reply was modified 3 years, 9 months ago by jim-moffatt.
            July 16, 2020 at 8:11 pm #208829
            Buccaneer
            Participant

              US Member

              Sounds all all turned out well!

              Prepare to be boarded!

            • Author
              Posts
            Viewing 5 posts - 1 through 5 (of 5 total)
            • You must be logged in to reply to this topic.