1958 Evinrude Fleetwin 7.5 7524

Home › Forum › Ask A Member › 1958 Evinrude Fleetwin 7.5 7524

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • January 4, 2023 at 9:13 am #270671
    William MacNeill
    Participant

      Hello all. I just acquired a 1958 Fleetwin 7.5 and looking for a copy of the parts catalog for it. Would anyone have a copy they could share? The 57 parts catalog is available in the inner sanctum and probably not much had changed between the two years.

      The motor is very clean, 1 owner and was serviced before being put away 10 years ago. I’m hoping that this story is true I was told. In the event it does need some work it’s always good to have the correct parts catalog at hand if possible.

      Thanks in advance.

      Bill

      January 4, 2023 at 9:53 am #270676
      fleetwin
      Participant

        US Member

        Bill

        I have a parts list for this engine.  PM me with your email and I will get it to you.  Don

        January 4, 2023 at 11:04 am #270679
        aquasonic
        Participant

          Can’t think of any difference between a 1957 and 1958 Fleetwin other than the medallions, paint, and decals.

          Improvise-Adapt-Overcome

          • This reply was modified 3 years ago by aquasonic.
          January 5, 2023 at 5:15 pm #270707
          William MacNeill
          Participant

            I am still looking for the parts manual for the 58 Fleetwin 7.5  if anyone can help.

            I am also looking for the parts list for a 55 Fleetwin 7.5 that I picked up over the summer. I just looked under the hood for the first time. When checking compression the bottom cylinder was bored larger and the helicoil came out with the plug. I decided to put a new head on it and there are a few available on Ebay. Is the part # 277375 for the 57 in the Inner Sanctum the same used in 55? The part number listed for the 55 on ebay is 277375 but the casing is stamped 203656. I want to be sure I am purchasing the correct part. The head is only 20.00. Also the part # for the head gasket would be greatly appreciated. Thanks in advance.

            Bill

             

             

            January 5, 2023 at 5:54 pm #270709
            crosbyman
            Participant

              Canada Member

              see parts  in 2-3 shots

              Joining AOMCI has priviledges 🙂

              January 5, 2023 at 5:58 pm #270715
              crosbyman
              Participant

                Canada Member

                SEE PICS

                Joining AOMCI has priviledges 🙂

                January 5, 2023 at 6:03 pm #270720
                crosbyman
                Participant

                  Canada Member

                  SEE REST OF

                  Joining AOMCI has priviledges 🙂

                  January 5, 2023 at 6:10 pm #270726
                  William MacNeill
                  Participant

                    Thank you crosbyman.

                  • Author
                    Posts
                  Viewing 8 posts - 1 through 8 (of 8 total)
                  • You must be logged in to reply to this topic.