Topic: 1967 Evinrude 9.5 Carburator problem – Antique Outboard Motor Club,Inc

This topic has 5 replies, 4 voices, and was last updated 8 years, 7 months ago by fishingnuts.

Viewing 6 posts - 1 through 6 (of 6 total)

Author

Posts
June 7, 2017 at 11:05 pm #7273
fishingnuts
Participant
I have a rebuild kit for a carburator off a 1967 9.5 hp evinrude. When removing the aluminum plugs to clean out the ports I ran into a plastic piece close to the idle adjustment screw. Unable to remove this piece to clean out the ports, the three little holes for Idle. It will not move and I know there is some blockage behind this insert. Anyone know how to remove this insert???????????
June 8, 2017 at 12:38 am #59233
crosbyman
Participant
Canada Member
deletd

Joining AOMCI has priviledges 🙂
June 8, 2017 at 12:01 pm #59260
fleetwin
Participant
US Member
can you post a picture?

http://www.marineengine.com/parts/johns … etor+Group

Is item 57 what you are referring to? I seem to remember this strange plastic filler piece but don’t know much about it….
Frank will know…
June 8, 2017 at 3:14 pm #59272
seakaye12
Participant
US MEMBER PAY BY CHECK
It is called a "Filler Plug" OMC #0312909. It is talked about in this thread:

viewtopic.php?f=2&t=10802&p=56866&hilit=312909#p56866

The later version 9.5’s used them. Most likely you will destroy it getting it out….and will have to order one; as they are not included in the carb kits.
June 11, 2017 at 4:28 pm #59472
fishingnuts
Participant
Thanks, as I did destroy it getting it out.
June 11, 2017 at 4:34 pm #59473
fishingnuts
Participant
Ordered a replacement filler plug. Whats the preset on the low speed idle adjustment. 1 1/2 turns out or more??
Author

Posts

Viewing 6 posts - 1 through 6 (of 6 total)

You must be logged in to reply to this topic.