I appreciate any help in advance. I was having some trouble with my motor listed in the title. I bought a carb rebuild kit and went at it. Not my first rebuild but a first on this one. I should note that I’m by no means an expert though. As I was finishing up I decided to remove a brass tube I saw to check for any other offices. It appeared to unscrew (slotted head) but it wouldn’t. I thought I could gently persuade it with channel locks. It smooshed a little and I quickly changed my mind about removing it. I’d better smoosh it back and move on I thought. The second smoosh destroyed it. Now here I am… 😑

I was told it’s called a nozzle. I found it to be called an emulsion tube in a couple places. I can’t find this particular part online anywhere. I also can’t find a replacement carb. The part is a holler brass tube. One end is cut at about 45 degrees. The other is flat with a few pin holes on the “shaft”. It goes from the float bowl up into the carb body. It’s pressed in, not screwed.

Any help with a replacement part or carb would be greatly appreciated. Thank you