9622a 9.5 sportwin gasket below impeller housing

Home › Forum › Ask A Member › 9622a 9.5 sportwin gasket below impeller housing

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • December 19, 2016 at 2:24 am #5923
    JACQUES
    Participant

      are home made cut-up gasket sufficient or do I need the real thing below the water pump housing

      impeller lower half…… part of the impeller body……. came out when I tried to pull the drive shaft seal 😮

      Joining AOMCI has priviledges 🙂

      December 19, 2016 at 2:39 am #49397
      frankr
      Participant

        If home made gaskets are not sufficient, a lot of us are in deep doo.

        December 19, 2016 at 3:28 am #49403
        chris-p
        Participant

          Yeah they are fairly easy ones to make.

          December 19, 2016 at 1:35 pm #49417
          JACQUES
          Participant

            thanks 🙂

            Joining AOMCI has priviledges 🙂

            December 20, 2016 at 12:29 am #49456
            Don
            Participant

              US Member

              In this case, I might even prefer a home made gasket. There aluminum wall is very thin around the outer edge, and the OEM gasket doesn’t cover it very well.

            • Author
              Posts
            Viewing 5 posts - 1 through 5 (of 5 total)
            • You must be logged in to reply to this topic.