Should I fabricate a jack plate for my boat?

Home › Forum › Ask A Member › Should I fabricate a jack plate for my boat?

Viewing 2 posts - 21 through 22 (of 22 total)
1 2 3
  • Author
    Posts
  • August 29, 2015 at 12:25 am #22852
    mr-asa
    Participant

      In general, I’m not planning on running a wide variety of motors with this boat. They will probably all be ’50s OMC motors, with a small handful outside that. All of them I run will be 15HP and under (as the boat is rated at 10HP, and I dont’ want to push it too much)
      I was thinking that (in general) the normal rear plate I have on there would work for all of my motors except for the 15HP.

      August 29, 2015 at 12:41 am #22853
      Casey Lynn
      Participant

        US Member

        Well there ya’ go! One jack plate height for a myriad of different engines, propellers and horsepower.
        Just think! After all that explanation it turned out to be this simple. Who’da thunk it!

      • Author
        Posts
      Viewing 2 posts - 21 through 22 (of 22 total)
      1 2 3
      • You must be logged in to reply to this topic.