Home Forum Ask A Member Spark plug? -1937 Muncie Neptune O B12A

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • #274486
    Buccaneer
    Participant

      US Member

      Anyone have a spark plug chart showing the correct 18mm spark plug
      for the 2 HP, 1937 Muncie Neptune O B12A?

      Could not find it on any of my data, nor online.

      Thanks.

      Prepare to be boarded!

      #274492
      MIKE SIMS
      Participant

        US Member

        From notes I have I can not see an OB12A, only an OB12. Earliest ’42 chart says an 6M, ’55 chart says 6MJ and my ’65 chart says K-15J

        #274497
        Tubs
        Participant



          Old Outboard Book says – 6M
          Old Outboard Book cross over chart says – K15J.
          Internet search –
          • Autolite 386
          • Champion D14
          • Champion D14013
          • Motorcraft BTS8F4
          • NGK 1010
          • NGK 2910
          • NGK A-6
          • NGK AB-6
          • NGK AB6
          • NGK stk 2910
          Tubs

          A "Boathouse Repair" is one thats done without having tools or the skills to do it properly.

          #274498
          Buccaneer
          Participant

            US Member

            Thank you both. I always forget about the “Old Outboard Book”,
            that was sitting two feet away, underneath some papers!
            I put a D16 in the one I fired up yesterday. Can’t remember
            if that’s Hotter or Colder than the recommended D14,
            but I have a chart for that!

            Prepare to be boarded!

            #274847
            Tubs
            Participant



              Just looking at the gas cap you made for the 36.
              Pretty cool!!!
              Tubs

              A "Boathouse Repair" is one thats done without having tools or the skills to do it properly.

              #274852
              Buccaneer
              Participant

                US Member

                Thanks Tubs. I was amazed it actually fit and
                screwed on okay. Internal threading in a blind
                hole is a challenge for me!

                Thanks for the spark plug data.
                I found some D-14’s so the little Neptunes
                should be “good to go”.



                Just looking at the gas cap you made for the 36.
                Pretty cool!!!
                Tubs

                Prepare to be boarded!

              Viewing 6 posts - 1 through 6 (of 6 total)
              • You must be logged in to reply to this topic.