1938 Speeditwin

Home › Forum › Ask A Member › 1938 Speeditwin

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • May 31, 2019 at 4:23 pm #176444
    fastjohn
    Participant

      US MEMBER PAY BY CHECK

      Will a tank from a late 40’s Speeditwin fit a 1938? Gary Spencer–would you please post the parts breakdone for this motor?
      Thanks

      June 1, 2019 at 6:39 am #176457
      garry-in-michigan
      Participant

        Lifetime Member

        The same tank was used on all Evinrude & Elto Speeditwins through the ’30s & 40s’. However in 1939 they did away with the stainless steel drum muffler and came out with a cast aluminum muffler model. These tanks have shorter rear brackets for the new muffler, but can be used on the older models with an adaptor.

        My-Speeditwin

        June 1, 2019 at 4:40 pm #176507
        garry-in-michigan
        Participant

          Lifetime Member

          P.S. – An assortment of parts books . . .
          1932


          1948


          1941

          1948

          June 1, 2019 at 6:07 pm #176512
          garry-in-michigan
          Participant

            Lifetime Member

            – P.S. – An assortment of parts books to fit your Speeditwin . . . [/color]
            1932


            1947


            1941

            i947

            June 3, 2019 at 5:26 am #176560
            garry-in-michigan
            Participant

              Lifetime Member

              OK – I will try again (I hope the third will be a charm) the first two disappeared when I hit the [SUBMIT] button –

              This is an assortment of parts books to try and cover what you need for your Speeditwin.
              Eat/y parts books were copies of pictures – like this – 1931


              In the late 1930s they started using copies of blue prints – this in 1941

              and these from1948.



              June 3, 2019 at 9:09 am #176565
              fastjohn
              Participant

                US MEMBER PAY BY CHECK

                Thanks Garry, that is what I was looking for.

              • Author
                Posts
              Viewing 6 posts - 1 through 6 (of 6 total)
              • You must be logged in to reply to this topic.