1953 super fastwin

Home › Forum › Ask A Member › 1953 super fastwin

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • December 14, 2023 at 9:47 am #283217
    Craig Allen
    Participant

      US Member

      I have a 1953 super fastwin I am restoring. I have pulled the lower end and am putting it back together. When I pulled it the drive shaft had a O-ring between the spines and a hard plastic washer on the shaft that would sit on top of the water pump housing. I do not see this hard washer on the parts list and can’t see any use for it. Can anyone tell me what  is suppose to be on the drive shaft before I reinstall it?

      1 user thanked author for this post.
      frankr
      December 14, 2023 at 1:34 pm #283219
      crosbyman
      Participant

        Canada Member

        any harm in just replacing it. ?

        Joining AOMCI has priviledges 🙂

        December 17, 2023 at 9:44 pm #283309
        jeff-register
        Participant

          US Member

          I had a 54 Superfastwin & loved it. I had an o ring about 1/2 the way on the upper driveshaft splines. It held the grease on the splines for lubing the coupling but no plastic of aby kind, I still have new oversize pistons & the rest to rebuild if you need anything. I forgot & sold my motor.

           

           

           

           

          7 the rest

          December 21, 2023 at 9:59 am #283384
          fleetwin
          Participant

            US Member

            Perhaps you can post a picture or two, don’t know of any hard plastic washers….

          • Author
            Posts
          Viewing 4 posts - 1 through 4 (of 4 total)
          • You must be logged in to reply to this topic.