Home › Forum › Ask A Member › CD-12 Gearcase Re-Seal › Re: CD-12 Gearcase Re-Seal
March 19, 2015 at 12:33 pm
#12326
Thank you Garry. I think I understand this now and it has been very educational for me. From another thread, it doesn’t sound as if Frank Robb makes the shift rod bushing tool anymore, but I can always ask him.
It looks as though the factory tool is larger in diameter than 5/16" on the ‘handle’ section probably to give it a little more contact area with the bushing and disperse the impact.
A lathe sure would be helpful for turning down some larger diameter stock. I may be calling on a machinist friend if I can’t get the tool from Frank.