1933 4HP Muncie OB4

Home › Forum › Ask A Member › 1933 4HP Muncie OB4

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • October 27, 2018 at 6:39 pm #11695
    kevinrude
    Participant

      Hey fellas,

      Does anyone have a service and/or parts manual for a Muncie OB4 (I just picked up one of these motors this AM)? I tried contacting Neptune Ned, but the email that I have for him is no good.

      BTW, is this one of those motors where the flywheel nut is also the puller and all you have to do to remove it is loosen the nut? How do you keep the flywheel still while loosening the nut? That thing is HUGE; bigger than any of my strap wrenches. Should the gas tank come off before attempting this?

      Thanks!

      Regards,
      Kevinrude

      October 27, 2018 at 6:40 pm #85058
      RICHARD A. WHITE
      Participant

        Lifetime Member

        Did you try calling him? I just spoke with him today

        http://www.richardsoutboardtools.com
        classicomctools@gmail.com

        October 27, 2018 at 6:49 pm #85060
        bill-loveland
        Participant

          I use an old serpentine belt on my strap wrench – it will go around a 55 gallon drum

          October 27, 2018 at 6:50 pm #85061
          kevinrude
          Participant
            quote Richard A. White:

            Did you try calling him? I just spoke with him today

            Ah, just found it! I might give him a ring later too. Thanks.

            October 27, 2018 at 9:59 pm #85073
            jmylaw
            Participant

              Kevinrude:
              Please post your experiences with the OB4. I just picked one up too.
              Jim

            • Author
              Posts
            Viewing 5 posts - 1 through 5 (of 5 total)
            • You must be logged in to reply to this topic.