Home › Forum › Ask A Member › 1957 Johnson 35hp 2-line Conversion
If I were to convert my 1957 Johnson 35hp from a 2-line pressurized fuel system, to a single-line fuel system, what would be the most recommended way of doing it, since I have seen many different ways? Thanks.
Find a fuel pump and bypass cover from a later model, bolt it up, change the fuel fitting, re plumb, plug old pressure barb, and Bobs your Uncle.
Chris, now you did it. You have all the non-Canadians Googling "Bob’s your Uncle".
Yeah. I ‘bit’……
I say "pardon me" a lot. I had a 20H, then raced open mod sleds.
I think you’ll find the 35 intake port already has the boss there – just need to drill the center one through and tap the other two holes.
The holes are already there because a fuel pump kit was a factory accessory item.
Would a fuel pump like this one work?
Attachments:
It will work if it isn’t too tall (don’t know). I do know the 18-7351 will fit
What would I do to the fuel nipple coming out of the intake? Plug it somehow?
Yep, put a vacuum tube cap and clamp on it.
https://shop.advanceautoparts.com/p/dor … lsrc=aw.ds
When you opt to “Remember Me”, WordPress will tell your browser to save the state of pages when you navigate away from them. This allows them to be restored instantly when you use the back and forward buttons in your browser.
OK
.
