1957 QD18 10HP Crankshaft Specs

Home › Forum › Ask A Member › 1957 QD18 10HP Crankshaft Specs

Viewing 5 posts - 1 through 5 (of 5 total)

  • Dave
    US Member - 1 Year (includes $3 online payment fee)
    Replies: 7
    Topics: 4
    May 4, 2021 at 10:31 pm #237731

    I am looking for the service specs for this crankshaft, specifically the center bearing and both of the piston rod journals. I found some info on this site showing the center bearing limits .9990-.9985 in. If that is correct great, but I did not find- or I did not understand- the limits for the two crankshaft/piston rod journals. Thanks in advance to anyone with the info.

    Dave Strickland
    1957 Johnson QD-18H 10HP


    frankr
    US Member - 1 Year (includes $3 online payment fee)
    Replies: 6715
    Topics: 51
    May 5, 2021 at 6:34 am #237734

    Top 0.8120 – 0.8125
    Center 0.9985 – 0.9990
    Bottom 0.8120 – 0.8125

    Crankpins 0.8145 – 0.8150

    • This reply was modified 2 years, 11 months ago by frankr.

    fleetwin
    US Member - 2 Years
    Replies: 4744
    Topics: 46
    May 5, 2021 at 6:59 am #237736

    Be sure to check the wrist pins/bushings for excess wear, this is a common issue with the 10hps before 1960….


    Dave
    US Member - 1 Year (includes $3 online payment fee)
    Replies: 7
    Topics: 4
    May 5, 2021 at 3:01 pm #237790

    thanks


    Dave
    US Member - 1 Year (includes $3 online payment fee)
    Replies: 7
    Topics: 4
    May 6, 2021 at 9:07 pm #237884

    I have a good crankshaft. Top and bottom bearings are within a 10 thousandth, at .8123 The middle bearing is at .9986, and the crankpins are .8155 Thanks for all the help!

Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.