Home › Forum › Ask A Member › 0302035 wrong part number
- This topic has 7 replies, 6 voices, and was last updated 2 years, 7 months ago by Mumbles.
-
AuthorPosts
-
September 13, 2021 at 6:10 am #246560
1955 qd16
what is 0302035 superceded to ? i ordered the o ring that goes over the bottom crankshaft bearing
and marine engine sent me the wrong o ring the parts manual says 0302035 is for spacer to impeller housing o ring
please look at the parts manual for crank shaft section ,item number7 . the 1957 parts manual is also wrong
thanks for any helpSeptember 13, 2021 at 8:56 am #246565Looks like they were using the same part number in 1963.
https://www.aomci.org/forums/topic/1963-sportwin-o-ring-on-upper-crank-bearing/Marine Engine usually show the superceded parts numbers, if any.
If you have the old one, you could try buying a buna o-ring from a hardware
or auto parts store.Prepare to be boarded!
September 13, 2021 at 9:09 am #246566My 10hp (1959) original parts book sez 302035 is the number for the o-ring around the lower bearing and also for the lower end of the spacer. If ME is sending you the wrong size o-ring, their parts stock may be mixed up, wrong part in right stock box.
September 13, 2021 at 9:42 am #246567Frankr
i think your rightSeptember 13, 2021 at 10:39 am #246576Marineengine says that the carburetor on my 1981 Mercury 25HP is a Tillotson. Tillotson says it is not. So they are not exempt from making errors.
September 13, 2021 at 1:07 pm #246622Well, isn’t this interesting! 302035 is shown as the P/N for the ten horse lower bearing outer seal O ring and I can’t find anything in my Superceded Parts List saying it isn’t so it should be a good number. Searching that number brings up an O ring for the water pumps on newer motors. The OD of the ten horse crank bearing is 1 1/4″ while the sizes I find listed for the water pump 0302035 O ring are shown as 7/8 X 1 1/8 X 1/8. Is it possible the same part number is being used for the newer O ring as the original O ring with that part number hasn’t been used since 1963?
I think ME sent you the current O ring using that part number. Might be best to call them and see if they have any old stock with the same part number.
September 13, 2021 at 3:50 pm #246648Very interesting indeed…Will be interested in hearing how this plays out…
September 16, 2021 at 6:27 pm #246761Marineengine says that the carburetor on my 1981 Mercury 25HP is a Tillotson. Tillotson says it is not. So they are not exempt from making errors.
They also list the 1960 Johnson 18 horse motors as FD-18’s when they are in fact FD-14 models.
http://www.marineengine.com/parts/johnson-evinrude-parts.php?year=1960&hp=18&model=FD-18
-
AuthorPosts
- You must be logged in to reply to this topic.