Home › Forum › Ask A Member › 1949 Johnson 16hp Model SD-20
- This topic has 25 replies, 8 voices, and was last updated 3 years, 4 months ago by davidk.
-
AuthorPosts
-
November 27, 2020 at 11:53 pm #222527
YES, I agree! Going to hook up with him as soon as I can. That medallion is one I also need! Thanks to each of the responders-I have followed up with each but find this parts motor the one
with the most possibilities.November 28, 2020 at 1:08 pm #223858November 29, 2020 at 12:05 am #223910Oh Man! I have a long way to go. Can’t wait to get mine running, and then to finish. Yours is beautiful!
November 30, 2020 at 9:31 am #223962Here is a link to a video of my SD-20 running on Lake Christopher in Maine a few years back. These are a lot of fun to run.
David Bartlett
Pine Tree Boating Club Chapter"I don't fully understand everything I know!"
November 30, 2020 at 12:28 pm #223978Thank you – actually saw two videos of SD20’s running. Thank you thank you. Looking forward to getting mine running. Still have some more parts to find.
December 2, 2020 at 12:18 pm #224116Picked up the parts motor near Juda, Wisconsin yesterday. It looks much better than I imagined – has a good propeller too. For $20, it was a very good buy, and
included a 600+ mile day trip which was very enjoyable. Still have more parts to search for and will check the other source named previously – Dan I believe. Thanks
to each of you. Enjoyed the photos and video = very helpful.December 3, 2020 at 12:02 am #224156Went to Juda, WI and picked up that parts motor, which is an older SD model, but has several parts that I can use, Fun day trip with over 600
miles. Enjoyed it. Will continue my search for some other parts – will check with Dan, as supplied above. Thanks to all – enjoyed videos and photos.December 4, 2020 at 7:45 am #224193Although I may utlimately not be able to help, depending on just what is desired, I did send you a private message several days ago.
Seasons Greetings,
JoeDecember 4, 2020 at 9:35 am #224211Thank you for writing. I reviewed your private message when I received it. At the time, it seemed as tho’ you wouldn’t have parts for a motor as old as 1949. It was mentioned, a
recoil assembly for $49.99, and another part also. If I am wrong, please advise.. Seasons greetings to you, and hope your weather in Atlanta has warmed ujp!Errol Stillings
December 4, 2020 at 1:18 pm #224216Hi Errol,
Thank you for your kind reply. It may be true that the only new old stock parts we have at hand for a SD-20 are the two I messaged you about, but as I also commented, we do have a factory parts manual for the SD-20, and it is not impossible that we might have or can source another part or more (we have very long had quite a good number of post WWII to early 1960’s Evinrude or Johnson outboard parts manuals). We are far better with Mercury products, as we were a dealer for 50+ years (our family business was founded 70 years ago in 2021, and has been it’s present incorporated name for 65 years in 33 days and counting down), but we do inventory a selection of OMC parts as well.
Our weather is a little below average right now for this time of the year, but still a nice place to be.Thanks Again,
Joe -
AuthorPosts
- You must be logged in to reply to this topic.