WEST BEND/CHRYSLER/SEA KING

Home › Forum › Ask A Member › WEST BEND/CHRYSLER/SEA KING

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • July 11, 2018 at 10:35 pm #10523
    guzzi-john
    Participant

      I have a1966 6hp twin. It has chunk of one blade so am planning to just remove a symmetrical piece from the other blade. just wondering if in the giant web there might be a cross reference to props, shaft size & spline etc. I know-pie in sky but maybe. I posted a bit about fixing the blown out snap ring bearing retainer last year. It runs VG so being as I have no boat my next project is grafting a transom on a free Wet Jet hull.

      July 12, 2018 at 12:13 am #79401
      frankr
      Participant

        US Member

        Might be expensive, but if all else fails that prop can be repaired good as new by a prop shop.

        July 12, 2018 at 12:26 am #79404
        outbdnut2
        Participant

          US Member

          Try posting a "Wanted" ad at our classified board here – someone is likely to have one, and the ad is free.
          Dave

        • Author
          Posts
        Viewing 3 posts - 1 through 3 (of 3 total)
        • You must be logged in to reply to this topic.